Building the walls

5

IMG_5514 IMG_5516 IMG_5518 IMG_5519 IMG_5521 IMG_5537 IMG_5541 IMG_5543

1 2 3 4 5 6 7
Share.

About Author

  • It’s probably right in front of me somewhere but what did you skin the inside of the walls with?

    • 5’x5′ 1/8″ baltic birch plywood.

  • Ian Moore

    Hey Ryan,

    Just curious – you used epoxy on the edges of the walls where they come into contact with the metal frame. However later on for the interior of the trailer you used spar varnish. Any reason you can think of why the Minwax spar varnish wouldn’t work in place of the epoxy on the wall edges? I figure they are both means to solving the same problem of waterproofing the wood.

    • That should work fine but it is not a permanent water barrier for external uses and might need to be reapplied in the future. Since most water intrusion would occur on the edge that shouldn’t be an issue to reapply if needed. Take a look at Thompson’s Waterseal instead, it is meant for this purpose and might be a better solution.

      The reason I used epoxy was that I knew I would never have to think about it again, also I had it laying around and was eager to test it out 🙂

  • Mickyeadams

    Hi,
    I’m starting to get a woodworking tool set and learning to use my router and saws as I gear up to make my first TD using your amazing plans. I see some doors from Vintage Tech measuring 26X36 inches and it looks like I have room to increase the door height. Do you see any issues with this?
    Mickye